LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2015 >> Verano Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Brake Pressure Modulator Valve Bracket Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING:

Refer to Brake Fluid Irritant Warning .

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

  1. Turn the ignition to the OFF position.
    2. Fig 1: Radiator Surge Tank And Clip
    GM2027873Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT disconnect engine coolant hoses.

  2. Remove the radiator surge tank clip (2).
  3. Remove the radiator surge tank (1).

    Position the radiator surge tank (1) aside.

    4. CAUTION:

    Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

  4. Disconnect the electrical connector from the EBCM/EBTCM.
    5. Fig 2: BPMV Brake Lines
    GM2027877Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Cap the brake pipe fittings to prevent brake fluid loss and contamination.

  5. Remove the 6 brake pipes (1, 2) from the BPMV.
    6. Fig 3: BPMV and BPMV Bracket Bolts
    GM2027887Courtesy of GENERAL MOTORS COMPANY
  6. Remove the 2 BPMV bracket bolts (2).
  7. Remove the BPMV bracket assembly (1).
    8. Fig 4: BPMV and BPMV Bracket Bolts
    GM2027916Courtesy of GENERAL MOTORS COMPANY
  8. Remove the 3 BPMV bracket bolts.
  9. Remove the BPMV (2).
  10. Remove the BPMV insulator (1) from the BPMV bracket (3).
scientia non olet · About LEMON Manuals