Front View Camera Module Calibration: Calibration: Notes

WARNING: This page is about a different car, the 2016 Chevrolet Malibu Limited. However, it is still accessible from the selected car via links, so may be relevant.

For North American SPS users, Calibration will NOT start automatically and will need to be initiated with GDS2. For European SPS users, Calibration will start automatically and will not need to be initiated with GDS2.

The calibration process for the front view camera system is necessary when a front view camera module is replaced by a new one. This process shall not be required when only replacing the windshield and the front view camera module has been mounted again properly. This process shall be completed within 3-5 minutes when the correct driving conditions are met. If conditions are not met correct, the front view camera module shall continuously run the service point calibration until successfully completed. This process shall work across ignition cycles and shall not be required to be re-initialized at start up. If the Lane Departure Warning Switch is pressed during calibration, the indictor will flash momentarily and then stay out - this is normal operation.

To calibrate the front camera, operate the vehicle in the following conditions until the calibration is complete:

Clean windshield.
Avoid lane changes.
Maintain vehicle speeds between 56-90 km/h (35-56 MPH).
Ensure the road contains visible references (well defined lane markings, curbs, etc.).