Communication Interface Module Bracket Replacement (Encore)

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Communication Interface Module Bracket (Encore)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement . Remove the instrument panel lower trim panel insulator. Refer to Instrument Panel Lower Trim Panel Insulator Replacement . Remove the floor auxiliary mat lower retainer. Refer to Floor Auxiliary Mat Lower Retainer Replacement (Encore) . Remove the instrument panel lower airbag - passenger side. Refer to Instrument Panel Lower Airbag Replacement - Passenger Side (AYF) .
1	Communication Interface Module Bracket Bolts (Qty: 2) CAUTION: Refer to Fastener Caution .
2	Communication Interface Module Bracket Procedure Disconnect the electrical connectors. Transfer components as necessary. The top of the bracket has 2 locking tabs on an arm that goes above the instrument panel tie bar, lift the arm up and out of the locking holes to release the bracket.

Callout

Component Name

Preliminary Procedures

Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement .
Remove the instrument panel lower trim panel insulator. Refer to Instrument Panel Lower Trim Panel Insulator Replacement .
Remove the floor auxiliary mat lower retainer. Refer to Floor Auxiliary Mat Lower Retainer Replacement (Encore) .
Remove the instrument panel lower airbag - passenger side. Refer to Instrument Panel Lower Airbag Replacement - Passenger Side (AYF) .

Communication Interface Module Bracket Bolts (Qty: 2)

CAUTION:

Refer to Fastener Caution .

Communication Interface Module Bracket

Procedure

Disconnect the electrical connectors.
Transfer components as necessary.
The top of the bracket has 2 locking tabs on an arm that goes above the instrument panel tie bar, lift the arm up and out of the locking holes to release the bracket.