Replace and Program Control Module or Reprogram Control Module

To program a replacement or an existing control module, perform the following procedure:

Without Rear Seat Video Entertainment System 

This control module does not require SPS programming or any setup procedures.

With Rear Seat Video Entertainment System

1. Install the EL-49642  SPS Programming Support Tool.
2. Connect a USB drive to the computer.
NOTE:

If using a pre-configured USB drive supplied by General Motors, proceed to step 8.

3. Access the Service Programming System (SPS) and follow the on-screen instructions.
NOTE:

Warehoused parts may not have current software on them. The following step will verify the module has the latest software version.

4. On the SPS Supported Controllers screen, select Media Disc Player - USB File Transfer and follow the on-screen instructions.
NOTE:
• If there are no updates available for USB transfer via SPS, proceed to step 10.
• All existing files on the USB drive will be erased when the new files are copied.
5. Upon completion of the file transfer, remove the USB drive from the computer.
6. Ignition ON, infotainment system ON.
7. Connect the USB drive to the rear seat USB port in the vehicle.
8. The infotainment system will recognize that update files are available. Follow the infotainment display on-screen instructions and select Update when prompted. Programming will take several minutes.
9. Upon completion of programming, remove the USB drive. Follow the infotainment display on-screen instructions.
10. On the SPS Supported Controllers screen, select Media Disc Player - Programming and follow the on-screen instructions.
11. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.