Replace and Program Control Module or Reprogram Control Module

To program a replacement or an existing control module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select B233 Radar Sensor Module - Short Range - Programming and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select B233 Radar Sensor Module - Short Range - Setup and follow the on-screen instructions.
4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
5. Following programming, the module ID must be programmed. With a scan tool, perform the Radar Sensor Module - Short Range learn procedure.