LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2017 >> Cascada Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. GM2028202

    Install the wheel speed sensor to the vehicle.

  2. Connect the electrical connector (1).
  3. GM2189141

    Install the wiring harness (2) retainers (3) to the TOP SIDE of brake hose (4), using the marking points of old wiring harness.

  4. Install the wiring harness (2) to the NEW body retainer (1).
  5. GM2028189

    Install the wheel speed sensor (1) to the steering knuckle.

  6. Install the wiring harness (3) at the bracket (4).
    7. CAUTION:

    Refer to Fastener Caution .

  7. Install the wheel speed sensor screw (2) and tighten to 6 N.m (53 lb in).
  8. GM2189142

    Check the correct installation position of the wiring harness (1). The wiring harness MUST be routed on top of the brake hose. If necessary adjust retainers (2) to the marking positions on the brake hose.

  9. Apply tension to the wiring harness (1) between the retainers (2) for the correct routing.
  10. Push down the brake hose by hand, to assure the correct installation position.
  11. Install the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
scientia non olet · About LEMON Manuals