LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2017 >> Cascada Base >> Repair and Diagnosis >> Engine Performance >> System >> Data Communication System >> Diagnostic Information and Procedures >> DTC U1653 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

NOTE:

Use the schematic and the connector end view to identify the device's serial data communication enable circuit and chassis high speed GMLAN serial data circuit terminals.

  1. Ignition/Vehicle OFF, disconnect the harness connectors at the device setting this DTC, ignition ON/Vehicle In Service Mode.
  2. Verify a test lamp illuminates between the serial data communication enable circuit terminal and ground.
    • If the test lamp does not illuminate 
    1. Ignition/Vehicle OFF, remove the test lamp, disconnect the harness connectors at the K9 Body Control Module.
    2. Test for infinite resistance between the serial data communication enable circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • Go to next step: If infinite resistance
    3. Test for less than 2 Ω in the serial data communication enable circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K9 Body Control Module.
    • Go to next step: If the test lamp illuminates 
  3. Test for less than 4.5 V between each chassis high speed GMLAN serial data circuit terminal and ground.
    • If 4.5 V or greater 

      Refer to DTC U0077  to test for a short to voltage.

    • Go to next step: If less than 4.5 V 
  4. Ignition/Vehicle OFF, all access doors closed, all vehicle systems OFF, and all keys at least 3 m (9.8 ft) away from vehicle. It may take up to 2 min for all vehicle systems to power down.
  5. Test for greater than 100 Ω between each chassis high speed GMLAN serial data circuit terminal and ground.
    • If 100 Ω or less 

      Refer to DTC U0077  to test for a short to ground.

    • Go to next step: If greater than 100 Ω 
  6. Test for less than 2 Ω in each of the chassis high speed GMLAN serial data circuits end to end between the harness connector at the device setting this DTC and the appropriate X84 Data Link Connector terminals listed below.
    • Chassis high speed GMLAN serial data circuit terminal 12
    • Chassis high speed GMLAN serial data circuit terminal 13
    • If 2 Ω or greater 

      Repair the open/high resistance in the serial data circuit.

    • Go to next step: If less than 2 Ω 
  7. Replace the device setting this DTC.