Replace and Program Control Module
NOTE:
During the procedures listed below, critical data is retrieved from vehicle components and stored in the scan tool computer's hard drive. This data is needed during the programming and setup sequences.
Ensure the same scan tool is used and capable of reading, storing, and writing the vehicle's system data.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Power Steering - Prepare Control Module for Removal and follow the on-screen instructions.
- Replace the Power Steering Assist Motor containing the Power Steering Control Module. Refer to Power Steering Assist Motor Replacement .
- With the Power Steering Assist Motor replaced and reconnected, on the SPS Supported Controllers screen, select Electronic Power Steering - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Power Steering - Configuration and follow the on-screen instructions.
- Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down.
- Ignition ON.
- On the SPS Supported Controllers screen, select Electronic Power Steering - Setup and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Power Steering - Endstop Learning procedure. Refer to Power Steering Control Module Calibration
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.