Removal & Installation
WARNING: This page is about the Cascada Base, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Includes: R&I Driveline Support Assembly; DOES NOT include Wheel Alignment. Includes:Drain and refill Low Temperature Cooling System. Includes: Drain and refill Transmission Fluid. | 11.2 | C | ||
| Combination Procedure: CONVERTER: Drain & Test: | ||||
| 0.2 | C | |||
| Combination Procedure: CONVERTER BUSHING & SEAL: Remove & Replace: | ||||
| Torque Converter Fluid Seal | 0.3 | B | ||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| Rear | 0.6 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: OUTPUT SHAFT SEAL: Remove & Replace: | ||||
| Each | 0.2 | B | ||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| 0.1 | C | |||
| Combination Procedure: TRANSAXLE ASSEMBLY: Replace: | ||||
| Includes: Programming. | 0.8 | C | ||