LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2017 >> Envision Base >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> Control Solenoid Valve and Transmission Control Module Assembly Programming and Setup (6T30/6T40/6T45/6T50) >> Programming an Existing or New Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming an Existing or New Control Module

This control module does not require SPS programming or any setup procedures.

This control module does not require SPS programming but does require the following setup procedures after a new control module is installed:

To program an existing or new control module, perform the following procedure:

  1. Install the special tool: EL-49642 SPS Programming Support Tool
  2. Ignition - On/Vehicle - In Service Mode
  3. Access SPS and follow the on-screen instructions for the control module: Q8 Control Solenoid Valve Assembly or K71 Transmission Control Module
  4. Perform the following learn procedure: Transmission Adaptive Values Learn
scientia non olet · About LEMON Manuals