Front View Camera Module Replacement

To program a replacement of the Front View Camera Module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.
NOTE:

After programming is performed, it is normal to have DTC B101E 4B set until calibration is complete.

3. If reprogramming an existing module that was previously calibrated, calibration is not required. The module retains its calibration settings during reprogramming. If a new module was programmed the module alignment must be calibrated. Using a scantool, initiate the learn procedure for Frontview Camera Module. The scantool must remain connected and on the calibration screen during the entire process.

   Refer to Front View Camera Module LearnFront View Camera Module Learn .