Body Control Module Programming and Setup: Introduction
WARNING: This page is about a different car, the 2017 GMC Acadia Limited, 2017 Chevrolet Traverse, and 2017 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
A new Body Control Module (BCM) must be programmed with the latest operating software and vehicle calibrations. Ensure that the following conditions exist in order to prepare for BCM programming:
- The battery is fully charged.
- The ignition switch is in the ON position.
- The Data Link Connector (DLC) is accessible.
- All control modules and devices are connected.
The procedures below are designed to program the Body Control Module (BCM) correctly during BCM related service. Before you start, read these procedures carefully and completely.