LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2018 >> Enclave Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Programming And Setup - All Systems) >> Repair Instructions >> Front and Rear Parking Assist Control Module Programming and Setup >> Unsuccessful Programming Recovery
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Unsuccessful Programming Recovery

WARNING: This page is about a different car, the 2017 GMC Acadia Limited, 2017 Chevrolet Traverse, and 2017 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

In the event of an interrupted or unsuccessful programming event, perform the following steps:

  1. Ignition ON. Ensure the K41 Front and Rear Parking Assist Control Module, DLC and programming tool connections are secure and the SPS software is up to date.
  2. Verify the K41 Front and Rear Parking Assist Control Module can be reprogrammed.
    • If the K41 Front and Rear Parking Assist Control Module cannot be reprogrammed 
    1. Ignition OFF for one minute, ignition ON.
    2. Verify the K41 Front and Rear Parking Assist Control Module can be reprogrammed.
      • If the K41 Front and Rear Parking Assist Control Module cannot be reprogrammed, replace the K41 Front and Rear Parking Assist Control Module.
      • If the K41 Front and Rear Parking Assist Control Module can be reprogrammed.
    3. All OK.
    • If the K41 Front and Rear Parking Assist Control Modulecan be reprogrammed 
  3. All OK.
scientia non olet · About LEMON Manuals