Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (without UGN)
WARNING: This page is about a different car, the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Due to continuous improvements, the on screen selections may vary from instructions below.
To program a replacement or an existing Front View Camera Module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield - Configuration and follow the on-screen instructions.
- Clear DTCs
- Following B174W Frontview Camera - Windshield replacement and reprogramming, the module must be calibrated. Refer to Front View Camera Module Learn .