Replace and Program Control Module
WARNING: This page is about a different car, the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, under Select Controller, select K182 Parking Assist Control Module.
- On the SPS Supported Controllers screen, under Select Function/Sequence, select Programming and follow on screen instructions.
- On the SPS Supported Controllers screen, under Select Function/Sequence, select Configuration and follow the on-screen instructions.
- Clear DTCs.