Checking and Adding Power Steering Fluid
- Run the engine until the power steering fluid reaches about 80°C (170°F).
- Turn the engine OFF.
- If the power steering fluid reservoir is covered by a shield or a cover, remove the shield or the cover, as applicable.
- Clean the power steering fluid reservoir and the reservoir cap.
- Remove the reservoir cap.
- Inspect the power steering fluid level in the reservoir or on the cap stick, as applicable. Ensure that the fluid level is at the HOT/FULL/MAX mark on the cap stick or on the reservoir, as applicable.
- Add power steering fluid if necessary. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the reservoir cap.
- If you removed a shield or a cover, install the shield or the cover, as applicable.
NOTE:
Inspect the power steering pump fluid level at regular intervals.
CAUTION:
When adding fluid or making a complete fluid change, always use the proper power steering fluid. Failure to use the proper fluid will cause hose and seal damage and fluid leaks.