Replace and Program Control Module or Reprogram Control Module

To program a replacement control module, perform the following procedure:

If "K36 Inflatable Restraint Sensing and Diagnostic Module - Programming and Setup" is shown

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K36 Inflatable Restraint Sensing and Diagnostic Module - Programming and Setup and follow the on-screen instructions.
3. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.

If "K36 Inflatable Restraint Sensing and Diagnostic Module - Programming and Setup" is not shown

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K36 Inflatable Restraint Sensing and Diagnostic Module - Programming and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K36 Inflatable Restraint Sensing and Diagnostic Module - Setup and follow the on-screen instructions.
4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.