Programming a New Control Module

To program a new control module, perform the following procedure:

1. Install the special tool: EL-49642 SPS Programming Support Tool
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K114B Hybrid/EV Powertrain Control Module 2 - Programming and follow the on-screen instructions.
4. At the end of programming, choose the "Clear All DTCs"
5. With a scan tool, perform the Clear Secured High Voltage DTCs and follow the on-screen instructions.
6. With a scan tool, Clear All DTCs.