Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Power Transfer Unit Alignment Sleeve |
| Power Transfer Unit Cover Housing Seal |
| Power Transfer Unit Face Seal |
| Power Transfer Unit Half Shaft Seal O-Ring |
| Power Transfer Unit Cover to Intermediate Drive Shaft Seal |
| Power Transfer Unit Gear Shaft Rear Seal - Case |
| Power Transfer Unit Gear Shaft Rear Seal - Cover |
| Power Transfer Unit Input Shaft Seal- Front |
| Power Transfer Unit Half Shaft Retainer Clip |
| Power Transfer Unit Propeller Shaft Retainer |
| Power Transfer Unit Propeller Shaft Seal - O-Ring |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Power Transfer Unit Drain Plug | 40 N.m (30 lb ft) |
| Power Transfer Unit Fill Plug | 40 N.m (30 lb ft) |
| Power Transfer Unit Extension Housing Bolt | |
|
28 N.m (21 lb ft) |
|
90 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Power Transfer Unit Case Bracket Bolt @ Engine | 22 N.m (16 lb ft) |
| Power Transfer Unit Case Bracket Bolt @ Rear Extension Housing | 58 N.m (43 lb ft) |
| Power Transfer Unit Case @ Transmission Bolt | 100 N.m (74 lb ft) |
| Power Transfer Unit Heat Shield Bolt | 12 N.m (106 lb in) |
| Power Transfer Unit Rear Output Shaft Flange Bolt | 35 N.m (26 lb ft) |
| Power Transfer Unit Vent Hose Connector | 25 N.m (18 lb ft) |