Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Catalytic Converter Gasket |
| Exhaust Front Pipe Gasket |
| Exhaust Gasket |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Catalytic Converter Heat Shield Bolt | 10 N.m (89 lb/in) |
| Exhaust Front Pipe Bracket Bolt | 22 N.m (16 lb-ft) |
| Exhaust Front Pipe Nut | 22 N.m (16 lb-ft) |
| Exhaust Front Pipe Nut at Warm Up Three-Way Catalytic Converter | 58 N.m (43 lb-ft) |
| Exhaust Front Underbody Heat Shield Retainer | 1.5 N.m (13 lb/in) |
| Exhaust Intermediate Hanger Bolt | 22 N.m (16 lb-ft) |
| Exhaust Muffler Flange Nut | 22 N.m (16 lb-ft) |
| Exhaust Rear Muffler Heat Shield Retainer | 1.5 N.m (13 lb/in) |
| Exhaust Rear Muffler Rear Hanger Bolt | 22 N.m (16 lb-ft) |
| Warm Up Three-Way Catalytic Converter Nut | 58 N.m (43 lb-ft) |