K26 Headlamp Control Module Programming

To program a replacement or existing control module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
NOTE:

On vehicles equipped with Electronic Suspension Control, it may be necessary to perform the Electronic Suspension Position Sensor Trim Height Calibration procedure before programming the K26 Headlamp Control Module.

2. On the SPS Supported Controllers screen, select K26 Headlamp Control Module - Programming and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K26 Headlamp Control Module - Setup while following the on-screen instructions.
4. Clear DTCs.