System Operational Test
NOTE:
Cycle system by turning ignition switch "OFF" and "ON". On Eldorado, Riviera, Seville and Toronado, transmission selector must be in "REVERSE". This procedure will reset the height sensor timer circuit.
- Measure vehicle riding height and start engine momentarily. Leave ignition switch "ON".
- Apply approximately 200 lbs. load to rear of vehicle.
- There should be 8-14 seconds delay before compressor turns on and vehicle begins to raise.
- Vehicle should raise to within 3/4" of riding height by the time compressor shuts off.
NOTE: Be sure applied load has not exceeded system capacity. This could cause failure of vehicle to rise to 3/4" of unloaded height. - After removing load, there should be 8-14 seconds delay before vehicle begins to lower.
- Vehicle should be within 3/4" of the unloaded height in 3 1/2 minutes.