Fuel System Pressure Test
- Remove "FUEL PUMP" fuse from fuse block in passenger compartment. Crank engine. Engine will start and run until fuel supply remaining in fuel lines is used. Engage starter again for about 3 seconds to assure all fuel is out of lines. Turn ignition off and replace fuse.
- Remove air cleaner and plug thermal vacuum port on throttle body. Remove steel fuel line between throttle body and fuel filter. When removing fuel line, always use 2 wrenches. Install a Fuel Pressure Gauge (J-29658 or equivalent) between throttle body and fuel filter.
- Start car and observe fuel pressure reading. Use Fuel System Diagnosis chart if pressure is not between 9-13 psi (.6-.9 kg/cm2 ). Use Injector System Diagnosis chart if pressure is between 9-13 psi (.6-.9 kg/cm2 ).
- Depressurize fuel system as described in step 1). Remove fuel pressure gauge and reinstall steel line between filter and throttle body. Start car and watch for leaks. Remove plug from throttle body thermal vacuum port and reinstall air cleaner.