Right Mirror Does Not Move Manually
NOTE:
After repair or component replacement is completed, perform MEMORY SYSTEM CHECK
under TESTING - SYSTEM CHECKS to verify system is operating properly.
- Perform MEMORY SYSTEM CHECK under TESTING - SYSTEM CHECKS. Go to next step.
- Using mirror select switch, select right mirror. Using test light, backprobe between outside mirror switch connector terminals "H" (Orange wire) and "F" (Purple/White wire). If test light illuminates, go to next step. If test light does not illuminate, go to step 7).
- Using test light, backprobe between outside mirror switch connector terminals "H" (Orange wire) and "G" (Red/White wire). If test light illuminates, go to next step. If test light does not illuminate, go to step 7).
- Using test light, backprobe between outside mirror switch connector terminal "H" (Orange wire) and Memory Mirror Module (MMM) connector C1, terminal E6 (Purple/White wire). If test light illuminates, go to next step. If test light does not illuminate, go to step 8).
- Using test light, backprobe between outside mirror switch connector terminal "H" (Orange wire) and MMM connector terminal F6 (Red/White wire). If test light illuminates, go to next step. If test light does not illuminate, go to step 9).
- Replace Memory Mirror Module (MMM).
- Replace outside mirror switch. See MIRRORS - POWER article.
- Repair open in circuit No. 889 (Purple/White wire) between outside mirror switch and MMM. See WIRING DIAGRAMS .
- Repair open in circuit No. 881 (Red/White wire) between outside mirror switch and MMM. See WIRING DIAGRAMS .