Transmitter Test
- Turn on Keyless Entry Tester (J43241). Place transmitter on J43241 tester pad. Press each button of transmitter one at a time. If a tone does not sound or the Green light does not illuminate after each button is pressed, go to next step. If a tone sounds and the Green light illuminates after each button is pressed, transmitter is okay.
- If none of the buttons sound tone or illuminate the Green light, go to next step. If any button sounds tone and illuminates Green light, go to step 5 .
- Replace transmitter battery and resynchronize transmitter. See TRANSMITTER SYNCHRONIZATION under programming. Go to next step.
- Turn on Keyless Entry Tester (J43241). Place transmitter on J43241 tester pad. Press each button of transmitter one at a time. If a tone does not sound or the Green light does not illuminate after each button is pressed, go to next step. If a tone sounds and the Green light illuminates after each button is pressed, go to step 6 .
- Replace transmitter and program new transmitter. See under PROGRAMMING. Go to step 7 .
- Operate transmitter within range of vehicle. If all RKE functions do not operate normally, go to next step. If all RKE functions operate normally, transmitter is okay.
- Perform synchronization procedure. See TRANSMITTER SYNCHRONIZATION . Operate system to verify repair.
NOTE:
Inspect keyless entry transmitter to ensure it is correct model for this vehicle. A wrong model transmitter may pass this test, but will not activate vehicle remote system.