Electronic Brake Traction Control Module (EBTCM): Installation
- To install, clean BPMV gasket surface with alcohol. Install 2 NEW wave springs in original location and position between EBTCM and BPMV. Install EBTCM to BPMV. Install 4 NEW top mounting screws and tighten in an "X" pattern to 26 INCH lbs. (2.9 N.m). Install 2 NEW bottom screws and tighten to 26 INCH lbs. (2.9 N.m).
- Connect pump motor connector at bottom of EBTCM. Connect EBTCM harness connector and push in lock tab. Install lower radiator hose to engine. Install ECM into relay center and install relay center cover. Turn ignition on, with engine off. Perform DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING.