Remote Keyless Entry (RKE) Transmitter
CAUTION:
If vehicle is equipped with radio anti-theft feature (THEFTLOCK(R)), obtain secret code from customer prior to disconnecting power to vehicle or removing RADIO fuse.
NOTE:
Programming of RKE transmitters can not be done simultaneously. First RKE transmitter must be programmed completely before programming next RKE transmitter(s). A maximum of 4 RKE transmitters may be programmed into BCM memory.
- Turn ignition switch to RUN position to deactivate Content Theft Deterrent (CTD) alarm system (if equipped). Turn ignition switch to OFF position. Remove RADIO fuse (25-amp) from instrument panel fuse block.
- Cycle ignition switch from OFF to RUN position 3 times within 5 seconds, leaving ignition switch in ON position. Body Control Module (BCM) will indicate programming sequence is active by activating hatch release, locking doors, then unlocking doors.
- Press and hold both LOCK and UNLOCK buttons on RKE transmitter to be programmed for 15 seconds. Doors will lock and unlock, and hatch release will activate to verify RKE transmitter has been recognized by BCM.
- Repeat step 3 for remaining RKE transmitters. After programming RKE transmitter(s), reinstall RADIO fuse. Turn ignition switch to OFF position.
NOTE:
While programming transmitters, wait for doors to unlock. Failure to do this, will cancel programming.