Fuel Leaks Outside Of Engine (6.6L)

NOTE: For component locations, see COMPONENT LOCATIONS .

Remove upper intake manifold sight shield using following procedure:
1. Remove retaining bolt in front of shield.
2. Lift up on front of shield.
3. Lift shield off rear bracket.
Clean all fuel lines between fuel injection pump and fuel injectors using brake cleaning solvent, and let dry.
Add 8 ounces of oil dye to fuel tank. On dual tanks, add dye to front, or primary tank.
Connect scan tool to Data Link Connector (DLC).
Start and idle engine for 3-5 minutes.
Command fuel pressure control to 23,206 psi (160 MPa) with scan tool.
Inspect for fuel leaks around fuel injection pump, junction block, fuel rails, and fuel injector supply lines with High Intensity Black Light Kit (J 28428-E). Tighten or replace any leaking lines or components. See 6.6L V8 DIESEL article in ENGINES, or appropriate REMOVAL, OVERHAUL & INSTALLATION article.