Assembly Procedure

Important:  Note the orientation of the variable assist steering actuator discharge fitting.

1. Lubricate and install the new O-ring seal with power steering fluid.
   CAUTION: Refer to FASTENER NOTICE .
2. Install the variable assist steering actuator (1) to the pump assembly.

   Tighten 

   Tighten the actuator to 62 N.m (46 lb ft).

3. Install the negative battery cable.

   Important:  If a new variable assist steering actuator (1) is being installed, position the electrical connector before installing the retaining ring (2).

4. Install the electrical connector to the variable assist steering actuator (1).
5. Install the retaining ring (2) to the variable assist steering actuator (1).
   Fig 1: Installing Variable Assist Steering Actuator

   Courtesy of GENERAL MOTORS CORP.