Procedure to Set Up a Rear Integration Module (RIM)

1. Ensure the scan tool has been updated with the latest software version.
2. Ensure the battery is fully charged.
3. Ensure all modules on the serial data line are connected.
4. Connect a scan tool to the data link connector (DLC).
5. Turn ON the ignition, with the engine OFF.
6. Under the dash integration module (DIM) main menu, select Special Functions. Under the Special Functions menu, one of the choices is Set Options.
7. Under the Set Options menu, the user selects from the following as available:
   • GM Trap Alert, to continue with the procedure follow the scan tool on screen instructions to deactivate GM Trap Alert.
   • Intrusion Sensor Part A, to continue with the procedure follow the scan tool on screen instructions to select the intrusion sensor.
   • Intrusion Sensor Part B, to continue with the procedure follow the scan tool on screen instructions to select the intrusion sensor.
   • Inclination Sensor Part A, to continue with the procedure follow the scan tool on screen instructions to select the inclination sensor.
   • Inclination Sensor Part B, to continue with the procedure follow the scan tool on screen instructions to select the inclination sensor.
   • Alarm Siren Module Part A, to continue with the procedure follow the scan tool on screen instructions to select the alarm siren module.
   • Alarm Siren Module Part B, to continue with the procedure follow the scan tool on screen instructions to select the alarm siren module.
   • Exit, to go back to Special Functions menu.
8. Cycle the ignition key OFF for 5 seconds, then ON to complete the procedure.

Important:  After programming, perform the following to avoid future misdiagnosis:

1. Turn the ignition OFF for 10 seconds.
2. Connect the scan tool to the data link connector.
3. Turn the ignition ON with the engine OFF.
4. Use the scan tool in order to retrieve history DTCs from all modules.
5. Clear all history DTCs.