Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Connect the electrical connectors to the DIM.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws securing the DIM top the I/P.
Tighten: Tighten the screws to 2 N.m (80 lb in).
Connect the closeout panel light electrical connector (1).

Fig 1: Locating Closeout Panel Light Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Install the I/P closeout panel. Refer to Closeout/Insulator Panel Replacement - Right .
Program the module. Refer to Body Control Module (BCM) Programming/RPO Configuration (RIM) or Body Control Module (BCM) Programming/RPO Configuration (DIM) .