Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the shift control boot. Refer to Floor Shift Control Boot Replacement .
- Remove the center console assembly. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
- Disconnect the wiring harness connector (1) from the shift lock control pigtail connector (2).
- Slide the pigtail connector (2) off of the retainer (3).
- Remove the pigtail harness from the wire retainer (4).
- Remove the three shift lock actuator attaching screws (1).
- Remove the shift lock actuator (2) from the shift control assembly.