LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2004 >> DeVille Protection Series >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) - 4.6L >> Repair Instructions >> Idle Air Control (IAC) Valve Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of IAC Valve & O-Ring
    GM481091Courtesy of GENERAL MOTORS CORP.
  1. Install the new IAC valve O-ring.
    2. Fig 2: View Of Idle Air Control Valve & Screws
    GM596334Courtesy of GENERAL MOTORS CORP.
  2. Install the IAC valve (1) into the throttle body.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the IAC valve attaching screws (2) into the IAC valve.

    Tighten:  Tighten the IAC valve attaching screws to 3 N.m (27 lb in).

    4. Fig 3: View Of IAC Connector and TP Sensor
    GM574138Courtesy of GENERAL MOTORS CORP.
  4. Install the electrical connector (1) into the idle air control valve (4).
  5. The powertrain control module (PCM) will reset the idle air control valve whenever the ignition switch is turned ON, then OFF.
  6. Turn the ignition switch ON.
  7. Turn the ignition switch OFF.
  8. Perform the IAC Valve learn procedure.

    IAC Valve Learn Procedure

    1. Start and idle the engine for 15 seconds.
    2. Turn the ignition switch to the LOCK/OFF position.
    3. Wait 15 seconds.
    4. Restart the engine, and check for proper idle operation.
scientia non olet · About LEMON Manuals