Installation Procedure

Fig 1: View Of Power Brake Booster Inlet Hose

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Installing Hoses Without Twists or Bends Notice in Cautions and Notices.

Route the hose in the same position the hose occupied prior to removal.
Install the brake booster inlet hose (1) to the brake booster (2). Hand tighten only.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the brake booster inlet hose to the power steering pump.
Tighten: Tighten the brake booster inlet hose fittings to 28 N.m (20 lb ft).
Remove the drain pan from under the vehicle.
Bleed the power steering system. Refer to Bleeding the Power Steering System .