Fastener Tightening Specifications

Application	Specification
Application	Metric	English
Accelerator Controls Cable Bracket Bolts	12 N.m	106 lb in
Accelerator Controls Pedal Assembly	9 N.m	80 lb in
Camshaft Position (CMP) Sensor Retaining Bolt	10 N.m	89 lb in
Crankshaft Position (CKP) Sensors Retaining Bolt	10 N.m	89 lb in
ECT Sensor	20 N.m	15 lb ft
EGR Heat Shield Nuts	9 N.m	80 lb in
EGR Pipe	60 N.m	44 lb ft
EGR Valve	24 N.m	18 lb ft
EVAP Canister	6 N.m	53 lb in
EVAP Canister Bracket Retainer Nut	6 N.m	53 lb in
EVAP Canister Purge Valve Bolt	12 N.m	106 lb in
EVAP Vent Valve Bolt	6 N.m	53 lb in
Fuel Filler Pipe Clamp	4.2 N.m	37 lb in
Fuel Filter Outlet Fitting	30 N.m	22 lb ft
Fuel Injector Sight Shield Nuts	2.3 N.m	20 lb in
Fuel Rail Assembly Studs	10 N.m	89 lb in
Fuel Rail Bracket Retainer Nut	10 N.m	89 lb in
Fuel Sender Access Panel Bolts	2 N.m	18 lb in
Fuel Tank Filler Pipe Ground Wire Attaching Bolt	9 N.m	80 lb in
Fuel Tank Retaining Strap Bolts	46 N.m	34 lb ft
Heated Oxygen Sensor (HO2S)	41 N.m	30 lb ft
Idle Air Control (IAC) Valve Attaching Bolts	3 N.m	27 lb in
Ignition Coil Cassette Retaining Bolts	9 N.m	80 lb in
Ignition Control Module Retaining Screws	0.8 N.m	7 lb in
Intake Air Duct Clamps	3 N.m	27 lb in
Knock Sensor (KS)	25 N.m	18 lb ft
Powertrain Control Module (PCM) Connector Screws	8 N.m	71 lb in
Rear Frame Bolts	100 N.m	74 lb ft
Secondary Air Injection (AIR) System Bolts/Nuts (Pumps, Shut-off Valves, etc.)	9 N.m	80 lb in
Spark Plugs	17-23 N.m	13-17 lb ft
Throttle Body Attaching Bolts	12 N.m	106 lb in
Throttle Position (TP) Sensor Attaching Screws	2.3 N.m	20 lb in
Water Pump Housing Bolt (EGR Crossover Pipe)	24 N.m	18 lb ft