LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2005 >> CTS V >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 5.7L - Introduction >> Repair Instructions >> Throttle Actuator Control (TAC) Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: View Of TAC Module & Wiring Harness Electrical Connectors
    GM1412216Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
    2. IMPORTANT:
    • Remove any debris from the throttle actuator control (TAC) module connector surfaces before servicing the TAC module. Inspect the TAC module connector gaskets if you diagnose or replace the TAC module. Verify that the gaskets are installed correctly. The gaskets prevent contaminate intrusion into the TAC module.
    • Do not touch the connector pins in order to prevent possible electrostatic discharge (ESD) damage to the TAC module.
    • The ignition should always be OFF if you install or remove the TAC module connectors.
  2. Remove the electrical connectors from the TAC module (1, 2).
  3. Remove the TAC module from the locking tabs on the relay center bracket.
  4. Remove the module from the vehicle.
scientia non olet · About LEMON Manuals