Removal Procedure
- Place the fuel pressure gage bleed hose into an approved container and open the bleed valve in order to bleed OFF fuel system pressure.
- Place a shop towel under the J 34730-1A
to catch any remaining fuel spillage. See Special Tools .
Courtesy of GENERAL MOTORS CORP.
- Remove the Fuel Pressure Gage from the fuel pressure connection.
- Drain any fuel remaining in the fuel pressure gage into an approved container.
- Inspect for leaks using the following procedure:
- Turn ON the ignition, with the engine OFF for 2 seconds.
- Turn OFF the ignition, for 10 seconds.
- Turn ON the ignition, with the engine OFF.
- Inspect for fuel leaks.
- Install the cap on the fuel pressure connection.
- Install the fuel injection sight shield. Refer to Fuel Injector Sight Shield Replacement
in Engine Mechanical.