Removal Procedure
CAUTION:
Refer to Brake Fluid Irritant Caution
in Cautions and Notices.
NOTE:
Refer to Brake Fluid Effects on Paint and Electrical Components Notice
in Cautions and Notices.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
in Engine Electrical.
Crimp the inlet hose (1) from the master cylinder to the Pre-Charge Pump (PCP) (2) to prevent fluid from leaking out and draining the master cylinder reservoir.
- Remove the inlet hose clamp from the PCP assembly inlet port.
- Remove the inlet hose (1) from the PCP assembly inlet port.
- Loosen and remove the brake fluid outlet pipe (3). Cap or plug the brake pipe to prevent contamination and brake fluid lose.
- Disconnect the PCP electrical connector from the vehicle connector harness.
- Remove the PCP electrical connector from the mounting bracket.
- Remove the PCP mounting bracket front bolt (2) and mounting bracket side bolts (3).
- Remove the PCP assembly (1) from the vehicle.
NOTE:
Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.
IMPORTANT:
The area around the pre-charge pump MUST be free from loose dirt to prevent contamination of disassembled ABS components.