Installation Procedure
Courtesy of GENERAL MOTORS CORP.
- Install the shift lock actuator wiring harness to the shift control assembly.
- Install the shift lock actuator (2) to the shift control assembly.
- Install the two screws (1) to the shift lock actuator (2).
- Install the tap up/down switch (3) to the shift control assembly.
- Install the two screws (1) to the tap up/down switch (3).
Courtesy of GENERAL MOTORS CORP.
- Install the shift indicator lamp sockets (1 and 2) to the shift indicator by rotating the lamp sockets one quarter turn. Note: if the shift indicator was removed in order to gain access to the lamp sockets, reinstall the shift indicator at this time. Refer to Shift Indicator Replacement
.
- Connect the wiring harness connector (3) to the shift lock control pigtail connector.
Courtesy of GENERAL MOTORS CORP.
- Install the center console assembly. Refer to Console Replacement - Front Floor
in Instrument Panel, Gages, and Console
- Install the shift control trim plate by inserting the front retaining tabs to the console. Then press down on the rear of the trim plate to engage the rear retaining tabs.