Removal & Installation
WARNING: This page is about the STS Base, 3.6 7, AWD, which is a different variant/trim than selected.
TRANS ID - 5L40E
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|
| Base,AWD | Includes: R&I Transfer Case Assembly. | 9.9 | | C |
| Combination Procedure: CONVERTER: Drain & Test: |
| Base | | 0.2 | | C |
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: |
| Base, Rear | | 0.4 | | B |
| Combination Procedure: FLYWHEEL: Remove & Replace: |
| Base | | 0.2 | | C |
| Combination Procedure: INPUT SHAFT SEAL: Remove & Replace: |
| Base | | 0.2 | | B |
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: |
| Base | | 0.1 | | C |
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: |
| Base | Includes: Programming. | 0.8 | | C |
TRANS ID - 5L50E
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|
| Base,AWD | Includes: R&I Transfer Case Assembly. | 5.7 | | C |
| Combination Procedure: CONVERTER: Drain & Test: |
| Base | | 0.2 | | C |
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: |
| Base, Rear | | 0.4 | | B |
| Combination Procedure: FLYWHEEL: Remove & Replace: |
| Base | | 0.2 | | C |
| Combination Procedure: INPUT SHAFT SEAL: Remove & Replace: |
| Base | | 0.2 | | B |
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: |
| Base | | 0.1 | | C |
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: |
| Base | Includes: Programming. | 0.8 | | C |