Body Control Module (BCM) Programming/RPO Configuration (RIM)

Body Control Module (BCM) Programming/RPO Configuration (RIM)

General Information to Set Up a Rear Integration Module (RIM)

Before setting up any option ensure the following:

* The scan tool has been updated with the latest software version.
* The battery is fully charged.
* All modules on the serial data line are connected.

Setting Options

Select Set Options under the DIM special functions menu, and follow the Tech 2 on-screen instructions. The following options need to be set, when the RIM is replaced. All listed options are for export only, and the selection should be No for domestic vehicles.

* Intrusion Sensor Part A
* Intrusion Sensor Part B
* Inclination Sensor Part A
* Inclination Sensor Part B
* Alarm Siren Module Part A
* Alarm Siren Module Part B

Important: After programming, perform the following to avoid future misdiagnosis:

1. Turn the ignition OFF for 10 seconds.
2. Connect the scan tool to the data link connector.
3. Turn the ignition ON, with the engine OFF.
4. Use the scan tool in order to retrieve history DTCs from all modules.
5. Clear all history DTCs.