Rear Body Control Module Replacement

Rear Body Control Module Replacement

Removal Procedure

1. Remove the rear shelf.




2. Remove the push pins securing the rear body control module (RBCM) (1) to the electrical carrier assembly.
3. Disconnect the electrical connectors.
4. Remove the RBCM.

Installation Procedure




1. Install the RBCM (1) to the electrical carrier.
2. Install the push pin fasteners.
3. Install the rear shelf. Refer to Shelf Carrier Replacement - Rear.
4. If installing a replacement RBCM, program the module. Refer to Control Module References for programming and setup information. Programming and Relearning