Installation Procedure

If removed, install the EBCM. Refer to Electronic Brake Control Module Replacement (W/JL4) or Electronic Brake Control Module Replacement (W/O JL4) .

Fig 1: View Of BPMV Bracket & Components

Courtesy of GENERAL MOTORS CORP.

If removed, install the bottom grommets (3) to the BPMV (2).
Install the side grommet (5) to the BPMV bracket.
Install the BPMV (2) on the mounting bracket.
Install the retaining bolt (1) to the BPMV (4).
NOTE: Refer to Fastener Notice .

Tighten: Tighten the bolt to 10 N.m (89 lb in).

Fig 2: View Of BPMV Bracket & Bolts

Courtesy of GENERAL MOTORS CORP.

Position the BPMV (2) to the frame.
Install the BPMV bracket bolts (1).
Tighten: Tighten the bolts (1) to 22 N.m (16 lb ft).

Fig 3: View Of Front Brake Pipes, Fittings & Frame Retainer

Courtesy of GENERAL MOTORS CORP.

Position the brake pipes (8) to the BPMV (4) and secure the retaining clip (9).
Install the brake pipe fittings (7).
Tighten: Tighten the fittings to 18 N.m (13 lb ft).

Fig 4: View Of Front Brake Pipe Fitting & Pipe

Courtesy of GENERAL MOTORS CORP.

Position the front brake pipe (6) to the BPMV (4).
Install the brake pipe fitting (5).
Tighten: Tighten the fitting to 18 N.m (13 lb ft).

Fig 5: View Of Rear Brake Pipe, Brake Pipe Fitting & Retaining Clip

Courtesy of GENERAL MOTORS CORP.

Position the rear brake pipe (3) to the BPMV (4) and secure the clip (1).
Install the brake pipe fitting (2).
Tighten: Tighten the fitting to 18 N.m (13 lb ft).
Connect the EBCM electrical connector.
Bleed the BPMV. Refer to Antilock Brake System Automated Bleed Procedure (W/JL4) or Antilock Brake System Automated Bleed Procedure (W/O JL4) .