LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement (W/JL4) >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

CAUTION: Refer to Brake Fluid Irritant Caution .
NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove all dirt and debris from the electronic brake control module (EBCM) and the brake pressure modulator valve (BPMV) before loosening or removing any of the components.
    3. IMPORTANT: DO NOT reuse the EBCM to BPMV screws. Install NEW screws.
    Fig 1: View Of EBCM, BPMV & Screws
    GM1702891Courtesy of GENERAL MOTORS CORP.
  3. Using denatured alcohol, clean the EBCM (2) and the BPMV (3).
  4. Disconnect the EBCM electrical connector.
  5. Remove and discard the EBCM to BPMV screws (1).
  6. Carefully pull the EBCM (2) from the BPMV (3).
  7. Remove the EBCM to BPMV gasket.
scientia non olet · About LEMON Manuals