LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Brake Booster Inlet Hose Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Power Brake Booster Inlet Hose
    GM650858Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer toInstalling Hoses Without Twists or Bends Notice .
  1. Route the hose in the same position the hose occupied prior to removal.
  2. Install the brake booster inlet hose (1) to the brake booster (2). Hand tighten only.
  3. Raise the vehicle.
    4. NOTE: Refer to Fastener Notice .
  4. Install the brake booster inlet hose to the power steering pump (3).

    Tighten:  Tighten the brake booster inlet hose fitting at the power steering pump to 32 N.m (24 lb ft).

  5. Install the engine protection shield. Refer to Engine Shield Replacement .
  6. Lower the vehicle.
  7. Tighten the brake booster inlet hose to brake booster.

    Tighten:  Tighten the brake booster inlet hose fitting to 32 N.m (24 lb ft).

  8. Remove the drain pan from under the vehicle.
  9. Bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals