April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

IMPORTANT: Perform the following procedure before installing the new tie rod ends:

Remove all traces of the oil, grease, or other contaminants.
Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
Apply red LOCTITE™ threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the inner tie rod.

Fig 1: View Of Inner Tie Rod End & J 34028

GM865341

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the inner tie rod to the relay rod.
Tighten: Using the J 34028 (2) tighten the tie rod to 100 N. See Special Tools .m (74 lb ft).
Install the outer tie rod end. Refer to Tie Rod Replacement - Outer .
Install the engine protection shield, if equipped. Refer to Engine Shield Replacement .
Lower the vehicle.
Verify the wheel alignment. Refer to Wheel Alignment Specifications .