Removal & Installation
WARNING: This page is about the STS Base, 3.6 7, AWD, which is a different variant/trim than selected.
TRANS ID - 5L40E
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Base,AWD | Includes: R&I Transfer Case Assembly. | 9.9 | C | |
| Combination Procedure: CONVERTER: Drain & Test: | ||||
| Base | 0.2 | C | ||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| Base, Rear | 0.4 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| Base | 0.2 | C | ||
| Combination Procedure: INPUT SHAFT SEAL: Remove & Replace: | ||||
| Base | 0.2 | B | ||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| Base | 0.1 | C | ||
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: | ||||
| Base | Includes: Programming. | 0.8 | C | |
TRANS ID - 6L45, 6L50, 6L80E, 6L90E
Includes: Bleed Brake System.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Base,AWD | Includes: R&I Transfer Case Assembly. | 6.9 | C | |
| Combination Procedure: CONVERTER: Drain & Test: | ||||
| Base | 0.2 | C | ||
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace: | ||||
| Base, Rear | 0.4 | B | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| Base | 0.2 | C | ||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| 0.1 | C | |||
| Combination Procedure: TORQUE CONVERTER SEAL: Remove & Replace: | ||||
| 0.2 | B | |||
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: Includes: Programming. | ||||
| Base | 0.8 | C | ||