LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Computer/Integrating Systems) >> Repair Instructions >> Body Control Module (BCM) Programming/RPO Configuration (IPM) >> BPP Sensor Calibration
April 5, 2026: LEMON Manuals is launched! Read the announcement.

BPP Sensor Calibration

WARNING: This page is about a different car, the 2006 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

This procedure needs to performed whenever IPM or BPP sensor was replaced. Refer to Brake Pedal Position Sensor Calibration .

IMPORTANT: After setup, perform the following to avoid future misdiagnosis:
  1. Turn the ignition OFF for 10 seconds.
  2. Connect the scan tool to the data link connector (DLC).
  3. Turn the ignition ON, with the engine OFF.
  4. Use the scan tool in order to retrieve history DTCs from all modules.
  5. Clear all history DTCs.
scientia non olet · About LEMON Manuals