LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2007 >> XLR Base >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless Entry System And Remote Functions >> Repair Instructions >> Transmitter Programming (Export - Including Canada) >> Method 2 - Service Programming System Fob Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Method 2 - Service Programming System Fob Programming

This procedure is a 10-minute relearn procedure using the Techline Terminal with SPS software. A scan tool, Techline Terminal and a replacement key fob are required to perform this procedure.

  1. Place the vehicle in the Vehicle On, Engine Off mode.
  2. Connect a scan tool to the vehicle.
  3. Insure that all power consuming devices are turned OFF on the vehicle.
  4. With a scan tool, select Request Info under Service Programming System and follow the scan tool on-screen instructions.
  5. Disconnect the scan tool from the vehicle and connect the scan tool to a Techline Terminal with the current Service Programming System (SPS) software.
  6. On the Techline Terminal, select Service Programming System and follow the Techline Terminal on-screen instructions. Select "VTD Vehicle Theft Deterrent Learn (Export Only)" under component replacement. Ensure that "Prepare RCDLR for key fob programming" is chosen.
  7. Disconnect the scan tool from the Techline Terminal and re-connect the scan tool to the vehicle.
  8. With a scan tool, select Program ECU under Service Programming System.
  9. At this point the scan tool must remain connected for the duration of the 10-minute relearn procedure.
  10. When the 10 minute relearn procedure has completed, place the transmission in Park (A/T) or Reverse (M/T) and turn the vehicle OFF.
  11. Using the scan tool, access the following:
    • Vehicle Control Systems
    • Computer/Integrating Systems
    • Module Replacement/Setup
    • RCDLR
    • Program Key Fobs
  12. Select Fob X (X = 1, 2, 3 or 4) on the scan tool. This will be the slot you wish to program to.
  13. Place the replacement key fob in the glove box pocket with the buttons facing right. A beep will occur indicating programming completion. The previously known fob is now erased.
  14. Press the OFF/ACC portion of the ignition switch to exit programming.
    15. IMPORTANT: Failure to operate the active portion of each key fob will result in that fob being inoperative. Pressing the active portion finishes the programming sequence and is require to ensure transmitter operation.
  15. Operate the active portion of each key fob to finalize the programming and verify correct system operation.
  16. If programming additional key fobs, repeat steps 1-15
  17. Clear any DTCs and remove the scan tool.
scientia non olet · About LEMON Manuals