LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2008 >> Escalade EXT >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Brake Booster Inlet Hose Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Power Brake Booster, Inlet Hose & Power Steering Pump
    GM650858Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Installing Hoses Without Twists Or Bends Notice .
  1. Install the power brake booster inlet hose (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
    IMPORTANT: Start both power brake booster inlet hose fittings by hand before finalizing torques.
  2. Connect the power brake booster inlet hose (1) to the power brake booster (2).

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  3. Connect the power brake booster inlet hose (1) to the power steering pump (3).

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  4. Clean any excess fluid from the vehicle and remove the drain pans.
  5. Install the engine shield. Refer to Engine Shield Replacement .
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals